| 發表人 | 內容 | ||||
|---|---|---|---|---|---|
|
ericni
資深會員   |
發表於: 星期一 2005-01-10 12:21
各位大哥覺得如何呢? 小弟個人覺得定價有點高 (NT:$94500) 覺得大約定在 NT:$80000 左右, 我比較能認同..... 那個手動的排氦閥, 還沒改進, 早該改成自動的了..... 目前這樣是裝飾噱頭大於實際功能..... 
個人覺得它很礙眼, 如果有人沒鎖好, 也是有進水的可能吧!?!? (雖然Omega說, 沒有鎖的時候也不會進水, 可是大家心裡不會毛毛的嗎?) Co-Axial 的穩定性, 現在有定論了嗎? (因為曾聽過有些前輩, 對於同軸還存有點觀望的態度!) 問一個自己亂想的問題: 數個零件同軸, 會不會增加軸的負擔? 造成防震力減低? 
|
||||
|
spikegifted
進階會員   |
發表於: 星期二 2005-01-11 01:38
Well, IMHO, I think the Co-axial version should be as good, if not better, as the original. OMEGA Co-axial movement has a free-sprung balance built-in - it offers reduced wear and greater stability of operation over long periods of time. As far as I can tell, the Co-axial mechanism is more than capable of powering the GMT... Although there isn't a chronometer based on the this movement, I think it's probably Omega hasn't refine the movement to squeeze in the additional functions. However, I got a feeling that it is just a matter of time.
|
||||
|
comet
初級會員   |
|||||
|
2046S
中級會員   |
|||||
|
hawk2004
進階會員 |
|||||
|
barlis
新進會員  |
|||||
|
pppleo
白金會員   |
發表於: 星期五 2005-02-11 21:12
2893改同軸縱擒,相當大路的機芯,準確度高,可惜不耐碰撞,就是不耐操的意思,這也是2892家族的通病 |
||||
|
peng0204
資深會員  |
|||||
|
j
初級會員 |
|||||
|
2046S
中級會員 |
發表於: 星期六 2005-02-12 11:54
請問不耐操是指什麼呢?很容易就故障?或是很容易就失去準度? |
||||
